Contract Laboratory has received the following incoming Laboratory Test Requests which need to be fulfilled! These Laboratory Test Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Independent, Third-Party Geophysical Laboratories to perform their Geophysical Testing, Analysis, Assays, Product Development, Scientific Research Experiments, Inspections, Certifications, and Engineering Projects. If you are a Geophysical laboratory that would like more information on these Geophysical projects, please visit Register Laboratories or call toll free 1-855-377-6821.
LONG-TERM TESTING Geophysical Laboratory needed for Particle Analysis: Particle Size Distribution by Laser Diffraction of Quartz, Fly Ash, GGBS etc. We require the Specific Surface area of the sample too, calculated by PSD analysis along with different D values and 1, 2 and 3 Sigma values as applicable and distribution results.
Geology laboratory needed for geophysical testing: Size, abrasive index, moisture content, bulk density, gradation
These tests need to be done on limestone and gypsum rock samples.
Geophysical laboratory needed to make geophysical measurements on 1-5 soil cores, each comprised of multiple test samples. The desired measurements include Compressional (P) and shear (S) wave seismic velocity, Electrical conductivity/resistivity, Dielectric permittivity, Hydraulic conductivity/permeability, Matric bulk density, Soil water retention parameters (van Genuchten alpha, n, m)
University Researcher needs Africa geology laboratory for Mineral deposite identification by geophysical means.
Middle East environmental laboratory needed for drinking water testing of water samples for different drinking water wells suspected to contain radionuclides, discovered during geophysical logging.
Middle East Environmental Laboratory needed for radionuclide testing: drinking water testing of water samples for different drinking water wells suspected to contain radionuclides , discovered during geophysical logging .
India geophysical laboratory needed for ground testing. test for sink holes under concrete up to thirty feet down
Geology Laboratory needed for stone geophysical testing: analysis on our natural stones including: analysis are: freezing, compressive strength, flexural strength, flexural strength under concentrated load, breaking load, determination of the breaking load at the fixing points, etc
Asia geophysical laboratory needed for Uniaxial compression testing of rock core samples. Direct shear testing of core samples
Asia geology laboratory needed for geophysical testing of andesitic rock for mpa and abrasion index and unconfined compressive strengths
University Engineering Research and Development Laboratory needs geophysical laboratory for Cerchar Abrasivity Index test on 8 samples.Laboratory needed for this tests.
Geophysical laboratory needed for Geophysical Measurements 30 core Samples, Tests Required Primary Wave Velocity Secondary Waves Velocity Dielectric Permittivity Electrical Resistvity Magnetic Susceptibility
Geophysical Laboratory needed for compressive strength testing of rock sample in MPA and also the geology type of the sample.
Geophysical Laboratory needed for isolating the content of Scheelite (CaWO4) that is in the raw ore as well as testing the concrete product.
California ASTM Geophysical Laboratory needed to measure hydraulic conductivity of soil, 2 samples
India Geophysical laboratory needed for ASTM Granite Physical property check as per ASTM C 615
Geophysical Laboratory needed for Masonry and Concrete Masonry Unit Testing Masonry Brick: ASTM C67 tests (compressive strength, absorption, freeze-thaw, and length change) Concrete Masonry Units: compressive strength (ASTM C140), linear drying shrinkage (ASTM C426), and freeze-thaw (ASTM C1262)