Contract Laboratory has received the following Laboratory Requests which need to be fulfilled! These Laboratory Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Labs to perform their Laboratory and Scientific Research. If you need a Laboratory, please Submit a Laboratory Request. If you need assistance or have questions contact us. Please log in to see more.
Looking for a certification for our infrared heating system product to sell it in the USA.
Need to determine the maximum film temperature at which thermal degradation (cracking) begins in Triethylene glycol (TEG).
MULTIPLE TESTING
UK Contract laboratory needed for the National Fire Protection Association (NFPA) and Loss Prevention Certification Board (LPCB) certifications for our fire ...
MULTIPLE TESTING
Third-party facility (India-based preferred) needed to perform heat transfer performance and pressure drop test on a fuel-cooled oil cooler used in heat exch...
UK contract lab needed to assess a product and verify its compliance with BS ISO 21927-9:2012 (BS 12101-9) - Smoke and heat control systems.
If you cannot verify the complia...
MULTIPLE TESTING
BUDGET APPROVED ($2,000-$5,000)
A large corporation needs a CANADIAN independent chemical testing facility to determine the Brunauer–Emmett–Teller (BET) iso...
Contract testing facility needed for CE & FCC compliance testing of HVAC controller products. Tests required are CE IEC 61326-1 and FCC Part 15B.
Contract Laboratory needed for testing a 5-ton-capacity Single Package Heat Pump Unit to AHRI 390 standards.
MULTIPLE TESTING
Materials Laboratory needed for ASTM Thermal conductivity testing at 25 C and 25 psi as per ASTM C518 (Standard Test Method for Steady-State Thermal Transmi...
USA LABORATORY (East coast preferred)
Industrial Laboratory needed for COP (Coefficient of Performance) and Capacity testing according to measurements published for new porta...
Contract Laboratory needed for IEC compliance testing of household electric heaters to the following IEC Test Standards: IEC 60675:1994 A1:1998 A2:2018 Household electric dire...
EUROPE LABORATORY
Europe Electrical Laboratory for certification testing of infrared heating panels according to the requirements of the IEC 60675 standard.
Contract Laboratory needed for chemical analysis on material that has been building up on the heaters in my alkaline chemical cleaning tank.
I would assume it is aluminum f...
Contract Laboratory needed for boiler ash sampling on ncinerator bottom ash and Fly Ash. can you provide a quotation for sampling asap please
NEW PRODUCT DEVELOPMENT
Contract Laboratory needed for CSA testing for the development of a combination space and water heating system a Hydronic AHU that will be paired wi...
LONG-TERM TESTING
Large Oil Company needs developing a new large-scale electric heater for a chemical plant fluid-solids unit heater tube design needs North American contra...
EUROPE LABORATORIES (Turkey Preferred)
MULTIPLE TESTS
MULTIPLE PRODUCTS
Europe Laboratory needed for multiple Non-Destructive NDT testing of Boilers and Pressure Vessels w...
INDIA LABORATORY
India Laboratory needed for condenser testing for Dust load
Stack pressure
NEW PRODUCT DEVELOPMENT
MULTIPLE PRODUCTS
USA Contract Laboratory needed for Development of a series of products for use in chimneys, wood stoves pellet stoves.
Performance Laboratory needed for ANSI/ASHRAE Dust Spot Efficiency Test for furnace air filter
USA LABORATORY (Midwest USA)
MULTIPLE TESTS
USA Electrical Laboratory needed for UL, ANSI and IEEE humidifier testing for commercial use.
Materials Laboratory needed for quartz testing for total temperature sustainability and UV light transmission for use in heating product.
UK Industrial Laboratory needed for ISO testing to ISO 21927-9 Smoke and heat control systems -- Part 9: Specification for control equipment
USA Product Safety Laboratory needed for multiple tests on electric polyester heating element including:
CSA, NEC/CEC, NFPA 70,CSA CEC 22.1
IEEE 215 or IEC 62395-1,
wate...
Forensics Laboratory needed for on-site inspection and failure investigation of failed industrial propane-fired heater involved in a fire and also possible testing of an exemp...
Industrial Laboratory needed for ASTM fire resisting duct work testing to ASTM E2336-16 Standard Test Methods for Fire Resistive Grease Duct Enclosure Systems and ASTM E2816-1...
Electrical Laboratory needed for fir safety of electrical radiant heating systems and its ability to start a fire when installed in domestic or Commercial applications.
Automotive laboratory needed for SAE testing of refrigerant hose assemblies to SAE J2064 standard (Refrigerant Automotive Air-Conditioned Hose)
Automotive parts company needs physical materials laboratory for ASTM flammability testing to ASTM D6668 - 01(2016) Standard Test Method for Discrimination Between Flammabilit...
Physical Laboratory needed for pressure drop and CFM airflow testing on HVAC cold air returns.
Physical Laboratory needed for heat exchanger testing for sound pressure level of our unit evaporator like below picture Please your information further about cost and duratio...
Electrical laboratory needed for Flow versus differential temperature comparison study as fuel passes a chamber with an electric heater.
Europe materials laboratory needed for ASTM and DIN Testing of lubricant oils to Copper Corrosion ASTM D 130/12 Aluminium Corrosion DIN EN ISO 6270-2 Ash content: DIN EN ISO ...
Ventilator company needs Laboratory for Fatigue testing of Centrifugal Fan Impellers of Mild Steel
UL, ETL, or NRTL recognized laboratory needed for certification testing of Domestic Storage Water Heaters (3 models) for export in US & Canada market to IEC 60335-2-21 standar...
Electrical laboratory needed for BS EN standard conformity testing to EN 442 Specification for radiators and convectors. Evaluation of conformity
ASIA PHYSICAL LABORATORY NEEDED FOR ASTM EDDY-CURRENT TESTING OF CONDENSER AND LOW PRESSURE/HIGH PRESSURE HEATERS OF POWER PLANT
Product Safety Testing Laboratory needed for CSA testing portable industrial oil-fired heater to get CSA certification. please tell how many heaters and ducuments we have to ...
Electrical laboratory needed to test 5500watt hot tub heaters that have failed causing fires and we would like to have them examined in a lab including x-rays.
If your Laboratory or Lab Supplier is interested in quoting or finding out more about the above Laboratory Requests or the many others that we have, e-mail us or view more Laboratory Requests