Laboratory Outsourcing and Scientific Sourcing Center

URGENT

MULTIPLE SAMPLES

Large Automotive Company needs USA Material testing laboratory for Comparative Tracking Index CTI testing on raw materials.

Contract Laboratory needed for SAE Lighting Testing to SAE J575 Test Methods and Equipment for Lighting Devices for Use on Vehicles Less than 2032 mm in Overall Width

MULTIPLE PRODUCTS
California Contract Laboratory needed for AES-100 reliability testing of electric vehicles EV and batteries

MULTIPLE TESTING
Automotive Laboratory needed for UNECER testing of 12meter coach bus accordance to UNECER 51.03 Uniform Provisions Concerning the Approval of Motor Vehicles ...

Specialty Vehicles Company needs USA Laboratory for identification of a chemical composition analysis on an unknown substance that was found alternators which failed inside ...

Environmental Simulation Laboratory needed for heat cycle testing on a large UPS size walk-in vehicle

FCC-Recognized Laboratory needed for FCC (federal Communications Commission) connectivity certification testing of an automotive aftermarket device for connectivity.

USA Contract Laboratory needed for ASTM oil residue testing per ASTM D 7066-04 on electric vehicle EV battery components

SWEDEN LABORATORY
PRODUCT DEVELOPMENT
MULTIPLE TESTING
Third-Party Electrical Laboratory needed for SWEDAC for EMC and Environmental testing on new Breath Alcohol Interlock...

Contract Laboratory needed for electrical gloves certification testing. The electrical gloves are used to work on Hybrid vehicle.

Accredited and Recognized Laboratory needed for ISO testing for e-bike with motor capacity less than 250w. export to USA and EU market. looking for lab that is recognized and ...

Large Automotive Company working on electric vehicle needs India Automotive Laboratory to test a Copper Bus Bar operating at different working conditions.
Below are few test ...

Large Automotive Company needs Electrical Laboratory for ASTM CTI (Comparative Tracking Index) of automotive electrical insulating materials according to ASTM D3638.

USA LABORATORY
MULTIPLE TESTS
Advanced Technology USA Electrical Laboratory needed for IEC Testing of Resin plaques for Ball Pressure and Glow Wire Ignition test according t...

MULTIPLE PRODUCTS
Automotive Laboratory needed for General Motors Specification Testing to GM15787 specification Vehicle Exterior and Add-On Parts Paint Appearance Requiremen...

Contract Laboratory needed for LSV/NEV electric vehicle California Air Resources Board CARB certification

UK Contract Laboratory needed for IPX9K test to ISO 20653 Road vehicles ? Degrees of protection (IP code) ? Protection of electrical equipment against foreign objects, water a...

Contract Automotive Laboratory needed for Flammability testing of 13 material specimens at suitable sizes supplied. The test method shall be as specified in IEC 60695-11-10. ...

Automotive Laboratory needed for SAE Testing for even-pin socket plug for car as per SAE J560 Standard test Primary and Auxiliary Seven Conductor Electrical Connector for Tru...

NEW PRODUCT
USA Automotive Laboratory needed for new automotive type battery connector voltage drop and vibration testing.I can send an overview of the type of tests to be co...

USA LABORATORY
MULTIPLE TESTS
Company needs USA Mechanical Laboratory for ASTM, ISTA, and AASHTO and other testing such as Max weight rating , crash-worthiness, wind drag , ...

Contract Laboratory needed for vibration testing according to Ford Electrical and Electronic Component Environmental Compatibility Test; CETP: 00.00-E-412, 201107, Section 5....