Contract Laboratory has received the following incoming Laboratory Test Requests which need to be fulfilled! These Laboratory Test Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Independent, Third-Party Wires and Wiring Laboratories to perform their Wires and Wiring Testing, Analysis, Assays, Product Development, Scientific Research Experiments, Inspections, Certifications, and Engineering Projects. If you are a Wires and Wiring laboratory that would like more information on these Wires and Wiring projects, please visit Register Laboratories or call toll free 1-855-377-6821.
ISO 17025 certified laboratory needed for OECD physical / chemical testing of solid materials and an octanol / water solution as per three OECD standard methods: OECD107 Partition Coefficient (n-octanol/water): shake flask method , OECD 117 Partition Coefficient (n-octanol/water), HPLC method, and OECD123 Partition Coefficient (1-octanol/water): slow-stirring method
Large cabling company needs a laboratory for fire resistance cable testing to BS 6387 Cat C W & Z.
1) Copper conductor, Mica tape, XLPE insulation, LSHF Bedding, Galvanized SWA and LSHF final Sheath.
3) Copper conductor, Mica tape, XLPE insulation, LSHF Bedding, AWA and LSHF final Sheath. This cables will be tested as per ( BS 6387 Cat C W & Z ).
ELectrical Laboratory needed for SAE Testing to Test impedance of twisted pair wires at 1MHz by the open and short methods per SAE J1939-11. Wires are 20AWG type TXL, standard specifies length of 3m.
Physical Laboratory needed which has an accreditation for the scope of the test methods in accordance with IEC 60754-1 - Test on gases evolved during combustion of materials from cables for raw material of Silicon electric wire. I would appreciate if you could send me a ROM quote including sample size and turnaround.
United Sates Materials Laboratory needed for copper wire testing for concentration and amount of impurities present in the sample,which elements it contain , how long will the results be ready and how would cost .
East Coast USA Physical Materials Laboratory needed for Micro hardness testing of silver-plated (less than 15wt% silver) copper flat wire Number of samples not yet known Samples are approximately 0.002in thick Presumably Vickers testing with a diamond tip would work best