Contract Laboratory has received the following Product Safety Laboratory Test Requests which need to be fulfilled! These Laboratory Test Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Independent, Third-Party Product Safety Laboratories to perform their Product Safety Testing, Analysis, Assays, Product Development, Scientific Research Experiments, Inspections, Certifications, and Engineering Projects. If you are a Product Safety laboratory that would like more information on these Product Safety projects, please visit our registration page or call toll us free 1-855-377-6821.
Test Request 17-01642
Product safety laboratory needed for OECD skin corrosion and irritation testing by in vitro methods OECD TG431, TG430, TG435, ...Apart from liquid product, also solid products should be tested. By experience, we know that the absorptive properties of silica-based carriers reduce the corrosivity of the liquid mixtures that are absorbed. However, this aspect is annihilated by adding water to the solid to facilitate the test procedure. Are there procedures available to test for corrosivity without requirement for added water?
Test Request 17-01556
Consumer Product Safety Laboratory needed for skin irritation testing of a fraction of essential oil (Leptospernmum Scoparium) which will be included in a carrier oil (Sweet Almond Oil)which I would like tested for skin irritation.
This fraction consists of Flavesone 15-25%, Iso-leptospermone 15-35%, Leptospermone - 50-60%, Grandiflorone0.50-4.0%.
I can supply samples for testing in different concentrations.
Test Request 17-00414
Medical device company needs clinical product safety laboratory for in vivo, in vitro and microbiology testing of disposable feminine pads including:
Surface device testing with just contact to the skin or breached/compromised surface (due to labial contact). We will do a limited exposure (less than 24 hours) testing.
Microbiology testing as pads release oxygen and slightly acidify the pH within the pad once blood reaches our patented powder. We want to see if it has any effect on microbes.
Measure the pH after blood has entered the pad to see how the pH is affected after blood has entered.
Amount of oxygen released per pad, the amount of CO2 absorbed per pad and the amount of humidity absorbed per pad?
Test Request 17-00379
URGENT TESTING FDA GMP Medical device preclinical laboratory needed for product safety and toxicity studies of a plastic dental aligner. Risk Assessment in regards to human exposure (oral, dermal, inhalation) is requested for a dental aligner and support-removal media. The dental plastic aligner is thermoformed onto a 3D printed mold that was previously soaked in our support-removal media.
Test Request 17-00128
Medical Device laboratory needed for ASTM and ISO product safety testing for evaluation of medical devices including toxicology, packaging and microbiology testing:
ASTM D7661-10, Standard Test Method for Determining Compatibility of Personal Lubricants with Natural Rubber Latex Condoms for compliance with latex and polyisoprene condoms.
ISO 10993-5 Biological Evaluation of Medical Devices-Part 5: Tests for in vitro cytotoxicity
ISO 10993-10 Biological Evaluation of Medical Devices-Part 10: Tests for irritation and skin sensitization
ISO 10993-11 Biological Evaluation of Medical Devices-Part 11: Tests for systemic toxicity
United States Pharmacopeia, National Formulary General Chapter <88>: Biological Reactivity Tests, In Vivo
USP <51> Antimicrobial Effectiveness Testing
USP <61> Microbiological Examination of Nonsterile Products: Microbial Enumeration Tests
USP <62> Microbiological Examination of Nonsterile Products: Tests for Specified Microorganisms
ISTA 3A: Packaged-Products for Parcel Delivery System Shipment 70 Kg (150 lb) or Less Shelf-life testing