Top

Incoming Power and Energry Laboratory Test Requests

Contract Laboratory has received the following Power and Energry Laboratory Test Requests which need to be fulfilled! These Laboratory Test Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Independent, Third-Party Power and Energry Laboratories to perform their Power and Energry Testing, Analysis, Assays, Product Development, Scientific Research Experiments, Inspections, Certifications, and Engineering Projects. If you are a Power and Energry laboratory that would like more information on these Power and Energry projects, please visit our registration page or call toll us free 1-855-377-6821.

Below are our 50 most recent Power and Energry laboratory test requests. Please log in to see more.

12-1886

Power and Energry

USA physical laboratory needed for thickness Testing. Test gold plating thickness in a .1x.1 inch area/location on a battery contact strip (12 contacts, each contact measures approximately .125" x.750".

Closed

17-01324

Exercise and Fitness

Consumer product safety laboratory needed for safety and durability testing of exercise harnesses

Submit Response

17-01325

Motor Vehicles and Automotive

Automotive mechanical laboratory needed for SAE burst and ozone testing of heavy duty machinery a/c hose and tube assemblies per SAE 2064,Refrigerant Automotive Air-Conditioned Hose

Submit Response

17-01326

Pharmaceuticals and Biopharmaceuticals

Large corporation needs DEA approved pharmaceutical laboratory to test the oxidation products of bench scale studies on controlled dangerous substances. Must be able to analyze for DEA Schedule II - V drugs.

Submit Response

17-01327

Medical Devices

FDA Medical device microbiology laboratory needed to perform multi-use testing assay on a liquid bandage medical device product. This assay is similar to USP51 testing and will use the 5 specified microbes, but it must have repetitious bioburdens applied to simulate a multi-use, (ie. ~50 uses) environment for the non-sterile liquid bandage product. The produc unit and the applicator with which bioburden contamination will occur is a propylene brush.

Submit Response

17-01328

Polymers

Plastics laboratory needed for shrink film testing for: puncture thumb edge, puncture sharp edge, tear strength and haze

Submit Response

Submit Power and Energry Testing Requests for Power and Energry testing and Power and Energry Scientific Research