Contract Laboratory has received the following incoming Laboratory Test Requests which need to be fulfilled! These Laboratory Test Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Independent, Third-Party Industrial Equipment and Suppies Laboratories to perform their Industrial Equipment and Suppies Testing, Analysis, Assays, Product Development, Scientific Research Experiments, Inspections, Certifications, and Engineering Projects. If you are a Industrial Equipment and Suppies laboratory that would like more information on these Industrial Equipment and Suppies projects, please visit Register Laboratories or call toll free 1-855-377-6821.
Industrial Manufacturer needs USA/China Physical Laboratory for cleanliness testing of industrial parts to millipore spec class B
USA/CANADA ISO MECHANICAL LABORATORY NEEDED FOR CONTAINER PROTOTYPE TEST
Thailand PCBA Manufacturing Company needs Electrical Laboratory for failure analysis of electrical component.
Metallurgical Laboratory needed for galvanized pipe couplings failure testing. We have 6" diameter couplings whose threads have failed after 6 months of service. The couplings were connected to stainless steel pipe in a groundwater well and the raw water has total dissolved solids concentration of over 1100 mg/l. I'd like an analysis to determine for the failure was from electrolysis/galvanic corrosion, wear or some other kind of corrosion. Ra ...
Analytical Chemistry Laboratory needed for flash point testing.
Radiological Laboratory needed for testing Epoxy base paste for radiation(10 to the 8th power) tolerance )radiation
USA Analytical Chemistry Laboratory needed for testing carbon, nitrogen and oxygen in cellulose acetate, cellulose triacetate, poly(vinyl acetate and unknown sample
Eastern USA Physical Laboratory needed for measuring the spray droplets from a sprayer - need to know the mass mean aerodynamic diameter array of the droplets.
Eastern USA ASTM Physical Laboratory needed for freezing point testing as per ASTM D1177 to certify for MIL PRF 25567E
USA ASTM Mechanical Laboratory needed for Climbing Drum Peel Testing on 4 composite sandwich panels in accordance to ASTM D-1781
Goregaon, Mumbai Mechanical Laboratory needed for surface roughness testing.
West Coast USA Optical Laboratory needed to measure the total reflectance from a single sample. The sample is coated metal, approximately 1in. x 2.5in. x 0.03in. The coating to be measured is on the large surface (not the edge). I would like a measurement scan from 350nm to 1050nm. As the coating appears uniform, the measurement spot diameter can be up to the full width (1 inch) of the sample or as small at 0.1inch; what ever is easiest to mea ...
JIS Analytical Chemistry Laboratory needed to perform chlorine resistance testing according to JIS K6762 on blue PE100 sample.
USA ASTM Metallurgical Laboratory needed for OEC full chemistry analysis as per ASTM A487, Gr. CA6NM cast material.
Southern CA ASTM, ASME, FDA/GMP Metallurgical Laboratory needed for non-destructive analysis/verification of raw material alloys, such as; 17-4 and other Stainless Steels, Ti 6AI-4V ELI Titanium, Aluminum, Etc.
Houston, TX Laboratory needed to UL certify Desiccant Dehumidifiers.
Ontario Mechanical Laboratory needed to perform lifting lug proof load tests on 3 centrifugal pump baseplates. Prefer Burlington / Mississauga / Toronto area
Eastern USA Metallurgical Laboratory needed for Elevated temperature (600F) galling test for Nitronic 60, Custom 450 and 17-4ph
Eastern USA Mechanical Laboratory needed for testing of galling of S21800 in combination with S17400, S21800 and S45000. Temperature of 600F required.