Top

Welcome!

ABOUT US

FIND LABORATORIES

LABORATORY REGISTRATION

SUPPORT

Email

Need Cables and Cabling Testing or Scientific Research?

Find Laboratories for all your Cables and Cabling Testing or Scientific Research!

Submit Cables and Cabling Laboratory Test Request

Cables and Cabling Laboratory Test Requests

Contract Laboratory has received the following incoming Laboratory Test Requests which need to be fulfilled! These Laboratory Test Requests are received from a variety of sources ranging from start-up companies to large, multinational Fortune 500 corporations, international organizations, well-respected universities and government agencies that are actively seeking Independent, Third-Party Cables and Cabling Laboratories to perform their Cables and Cabling Testing, Analysis, Assays, Product Development, Scientific Research Experiments, Inspections, Certifications, and Engineering Projects. If you are a Cables and Cabling laboratory that would like more information on these Cables and Cabling projects, please visit Register Laboratories or call toll free 1-855-377-6821.

16-02335

Cables and Cabling

Cable tie company in India needs laboratory to verify compliance with ICE 62275 standard.

Laboratory Needed

16-02265

Cables and Cabling

Test laboratory needed for SAE J1939-11 Table 7 cable tests for data cables (20 AWG). impedance and resistance, measurement of cables and shield effectiveness (surface transfer impedance according to MIL-C-85485)

Laboratory Needed

16-02233

Cables and Cabling

Electrical Laboratory needed for CE Mark Testing for Cables and Wires to .H05VVH2-F - H05VVH2-U - H05VV-F (TTR) - NYM - YAVV (NAYY) - YVV (NYY) - Self-supporting insulated wires SIP 5. Test cables and wires as evidence for CE certification for specified product groups: -

Laboratory Needed

16-02132

Telecommunications

Third-party testing laboratory needed for Ethernet cables (CAT6 and CAT6A) used in networking

Laboratory Needed

16-02072

Automotive and Motor Vehicle

Electrical Laboratory needed for conformance testing of automotive spark plug cables: ISO 3808 (or SAE J2031) for Spark Plug Cable. ISO 3808 or SEA J2031 when imports ?Spark Plug Cable?. There are two kinds of Spark Plug Cables need to get tested, 5mm (in diameter) cable and 7mm (in a diameter) cable. ?Spark Plug Cable? is component part of ?Spark Plug Cable Set? that comes with connector plugs On both end of cables, But we only need test dat ...

Laboratory Needed

16-01955

Telecommunications

Europe electrical laboratory needed for IEC tests on fibreoptic cables according to IEC IEC 60793-xx and 60794-xx standards: Testing fibreoptic cables on tensile performance, abrasion resistance, crush, impact, bending, kink, temperature cycling, water penetration, attenuation, PMD, chromatic dispersion, fire resistance, according to IEC Standard 60793-xx and 60794-xx. Following tests are required: IEC 60793-1-40 IEC 60793-1-48 IEC 60793-1- ...

Closed

16-01776

Medical Devices

Medical Device Company needs medical technology laboratory for packaging/ product /development of developing a disposable medical cable assembly that will require sterilization. ABS plastic housing for connectors Silicone vs PVC for cable assembly I have questions about cost, materials, packaging and logistics.

Closed

16-01734

Plastics

Large corporation needs physical laboratory needed for plastic cable testing: Load rating for pedestrian and vehicle (H-20, 40) for cable made of recycled plastic.

Closed

16-01706

Electronics

ISO 17025 accredited electrical laboratory needed for qualification testing of Medium Voltage Cables rated 5- through 46kV per AEIC CS8, Section 15 for the 120 Day Accelerated Water Treeing Test followed by test protocol to include Electrical Measurements, High Voltage Time Test, Physical Measurements, and Tree Count.

Closed

16-01568

Cables and Cabling

Electrical Laboratory needed for IEC Testing for Aluminium and nylon Cable Cleats as per attached specs IEC 61914:2009 (Old BS EN 50368) Cable Cleats & Short-Circuit Calculations For Electrical Engineers. Please quote your best price and lead time.

Closed

16-01343

Electronics

Electrical laboratory needed for failure investigation testing for lightning cable to specific problem (or problems) with a defective 8-pin lightning cable. Connector overheated and began to melt.

Closed

16-01308

Electronics

ELECTRICAL LABORATORY NEEDED FOR EN AND ANSI BASE PHOTOCELL TESTING (RECEPTACLE) TO ANSI C136.10: 2006 AND NTC 2470, Contact endurance test, Material and capacity of current contacts , Insulation Resistance, Dimensions, sizes and types of conductors connecting the tips, the basis for photocontrol, Base material or recetaculo connection, Dimensional analysis, Maración

Closed

16-01017

Cables and Cabling

ISO / IEC 17043 Proficiency Laboratory needed for Proficiency Testing in cables: 1. Insulation thickness 2. Conductor Tensile Strength

Closed

16-00937

Insulation and Insulators

ILAC Mutual Recognition Signatory Laboratory needed for Electrical ageing testing for insulation piercing connector for LV arial bundle cables as per NFC 33020 french standard

Closed

16-00738

Cables and Cabling

Mechanical Laboratory needed for electrical and mechanical properties testing of 0.40 PVC Shielded cable with 8 22 AWG conductors , we need to get the measures for below: Measure below Mechanical Properties Minimum permitted bend radius Measure below Electrical Properties Conductor resistance @ -10, 20 , 60 deg C Insulation resistance core to core Shield resistance Mutual Capacitance core / core (symmetrical) Mutual Capaci ...

Closed

16-00730

Information Technology

Technology Laboratory needed for Society of Motion Picture and Television Engineers SMPTE Testing to , SMPTE 425 and 2082. Specially with the jitter testing for SMPTE 425, and return loss and signal sensitivity for SMPTE 2082. Let me know if you want to have a conference call to review this request or if you can provide a quote.

Closed

16-00690

Cables and Cabling

Electrical laboratory needed for IEC testing of tape (synthetic) used in the fire resistance cables to sustain up to 800 deg celcius of temperature as per IEC-60331. The dimension of tape is 1) 8.00 mm/ 0.11 mm, We need below tests to be performed:- 1) Mica content (g/m2) 2)Glass content (g/m2) 3) Film Content (g/m2) 4) Bond glue content (g/m2) 5) Di electric strength (Kv/Layer) at a) 400 Deg Celcius b) 800 Deg. Celius (Important) 6) Maximum e ...

Closed

16-00668

Cables and Cabling

Contract Laboratory needed for IEC Testing of Copper tubular Cable lugs, Connectors to be tested as per IEC 1238-1:1993. AS/NZS 4325.1:1995 .

Closed

16-00588

Cabling company needs contract laboratory to perform Core qualification tests according to ICEA S-94-649/AEIC CS8, Standard for. Concentric Neutral Rated Cables

Closed

16-00485

Physical Laboratory needed for aluminum cable testing: Aluminum cable type ACAR 750 MCM 19 (6201) + 18 (1350). stress-strain for 5°, 25°,60°, y 80°C and a creep test for 1 hour, 24 hours, 48 hours, 72 hours y 10 years.

Laboratory Needed

16-00333

India laboratory needed for Cable wire testing

Laboratory Needed

Submit Cables and Cabling Testing Requests for Cables and Cabling testing and Cables and Cabling Scientific Research